CHAPTER 26
Replacing Host Subsystem Components
Replacing an M120 Routing Engine
Removing an M120 Routing Engine
Copyright © 2018, Juniper Networks, Inc.
Replacing an M120 Routing Engine on page 195
Replacing an SSD Drive on an RE-A-1800 or RE-S-1800 on page 198
Replacing a DIMM Module in M120 Routing Engines on page 200
Replacing an M120 CB on page 202
Replacing Connections to M120 Routing Engine Interface Ports on page 206
Replacing the Console or Auxiliary Cable on the M120 Routing Engine on page 209
Replacing the Management Ethernet Cable on the M120 Routing Engine on page 210
To replace a Routing Engine, perform the following procedures:
Removing an M120 Routing Engine on page 195
Installing an M120 Routing Engine on page 197
The router can have one or two Routing Engines. They are located within the CB in the
rear of the chassis on either side of the FEBs in the slots marked
Routing Engine weighs approximately 2.4 lb (1.1 kg).
and
. Each
CB0
CB1
195