Figure 51: Mts Lvd Kit Battery Cable Connections; Figure 52: Mts Lvd Kit Plus And Minus Signs - Motorola MTS LiTE Installation, Configuration And Basic Service Manual

b Two spare Ø6 terminals for 16 mm
these (not included).
c Click the protection cap on. Additional break away windows are available on cap allowing
multiple entry of cables.
NOTICE: Make sure no damage are done on cables by sharp edges on the cap.
d Check that cables are secured properly and tighten the included cable tie retainers.
WARNING: Be very careful not to short circuit the battery poles.
NOTICE: The cables shall not touch the metal housing.

Figure 51: MTS LVD Kit Battery Cable Connections

3 Note the small + and – signs on the side of the relay. The pole with the – sign is recommended
to be connected to the – pole on the battery.

Figure 52: MTS LVD Kit Plus and Minus Signs

4 Flip the backplate by hand, and insert the 2 rivet plugs as in the following figure.
2
cable are included. Special crimp tool applies on fitting
6802800U74-AN
Chapter 4: Hardware Installation
113