Other Can Bus Commands; Configuring And Verifying The Site Controller; Setting Up The Site Controller - Motorola MTS LiTE Installation, Configuration And Basic Service Manual

6802800U74-AN
Chapter 6: Configuration and Testing
Cavity VSWR Alarm – this Cavity Combiner is unable to tune. An actual value of VSWR is
shown.
Channel Spacing Alarm – means that frequency of one Base Radio is tuned too close to
another.
6.3.5

Other CAN Bus Commands

can check_mapping
Lists the registered, unregistered and unknown devices connected through CAN Bus.
Indicates possible cable corruption If there are no devices present.
Map all the not mapped devices.
6.4

Configuring and Verifying the Site Controller

The Site controller (SC) setup and checkout procedures specify steps that verify operation within the
Site Controller.
Process:
1 Verify the Site Controller configuration.
See Setting Up the Site Controller on page
2 Perform E1 (X.21) Loopback to test the E1 (X.21) interface and cabling.
See:
• E1 Connection Test on page 233
• X.21 Connection Test on page 233
3 Verify proper SRI functioning.
See Site Reference Check on page
6.4.1

Setting Up the Site Controller

Prerequisites: If an MTS or Site Controller is moved, clear the site location memory to force the stored
position data to be re-initialized. Enter the site_location -reset command on the Site Controller
terminal whilst the MTS is running in application mode.
Procedure:
1 Switch the Power Supply Unit on.
2 Start up the service terminal.
There is a series of self-tests. By default, after a few seconds, the Site Controller launches the
Site Controller Application. For description of other modes, see
Modes of Operation on page
3 At the prompt, enter status sc —all.
The command displays preliminary diagnostics information on the Site Controller. This includes
the health of the Site Controller, the trunking state, the internal state and the site link status.
232
232.
233.
222.
MMI Commands and MTS