Table of Contents
Advertisement
NOTICE: At this stage only connect the cable to the Site Controller.
NOTICE: If the Ethernet cable is being wired from a Base Radio in one Module Cage to a
Site Controller in another Module Cage, the Ethernet cable is to be drawn outside of the
Module Cage.
6 Insert the additional Base Radio by aligning the side rails with the appropriate rail guides inside
the Base Radio chassis.
7 Gently push the additional module completely into the Base Radio chassis assembly using the
module handle(s). Be careful not to damage any of the cables previously connected when
pushing the Base Radio into position.
8 Secure the additional module using two TORX screws. Tighten the screws to a torque of 2.7
Nm.
9 Connect the Power cables, Ethernet cable, Tx cable and Rx cables to the BR front plate.
NOTICE: If single or dual diversity, use QMA terminator (2866544A01) in unused Rx
connectors on Base Radio(s).
10 Switch ON the Power Supply Unit. You do not need to do this if doing a hotswap.
15.3.3
Configuration
Basic configuration of base radios is needed when additional base radio(s) has been added to the MTS
4 cabinet. This is described in
NOTICE:
Base radios in the second Module Cage should be configured with <cabinet>:<position>
set as 1:3 and 1:4.
NOTICE: For configurations with Manual Tuned Cavity Combiner(s), the MTCC needs to be
tuned after adding additional Base Radio.
In addition to this, the following parameters need to be configured in TESS application:
•
Factory password
•
Field password
•
Cabinet ID
•
Position ID
•
Carrier Number (TX/RX frequencies are auto-generated based on Carrier Number setting)
•
Default TX Power level
NOTICE: When these parameters have been configured in TESS Application and after the
modified configuration file has been uploaded to the Site Controller, the complete site needs to
be reset to implement the configuration change.
15.4
Redundant Site Controller
It is possible to add an additional (redundant) Site Controller to MTS 4. To add a redundant Site
Controller, two module cages must be present in the MTS 4.
NOTICE: If a redundant Site Controller is added to an MTS with an expansion cabinet, a
redundant XHUB must also be added.
Configuring and Verifying the Base Radio on page
6802800U74-AN
Chapter 15: Expansion Options
234.
431
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
