Figure 17: Mts Lite / Mts 2 - Drill Hole Position For The Mounting Brackets; Figure 18: Mts 4 And Expansion Cabinet - Drill Hole Position For The Mounting Brackets - Motorola MTS LiTE Installation, Configuration And Basic Service Manual

6802800U74-AN
Chapter 4: Hardware Installation
2 Mark and then drill the floor according to the dimensions shown in
– Drill Hole Position for the Mounting Brackets on page 92
Expansion Cabinet – Drill Hole Position for the Mounting Brackets on page
keep the 13 mm distance behind the mounting plate. In each bracket, a 12 mm hole is pre-
drilled. The front brackets can be placed anywhere around the leveling feet at a radius of 60 mm
or 105 mm (either hidden under the cabinet, or stuck out for easy mounting), see the circles in
Figure 17: MTS LiTE / MTS 2 – Drill Hole Position for the Mounting Brackets on page 92
Figure 18: MTS 4 and Expansion Cabinet – Drill Hole Position for the Mounting Brackets on
page 92.
Figure 17: MTS LiTE / MTS 2 – Drill Hole Position for the Mounting Brackets
Figure 18: MTS 4 and Expansion Cabinet – Drill Hole Position for the Mounting Brackets
3 Secure the two rear brackets to the floor using one screw for each bracket.
4 Place 2 screws for each front bracket (2x2) in the drilled holes. Screw them almost all the way
down but leave space rotate the bracket into position later.
92
Figure 17: MTS LiTE / MTS 2
and Figure 18: MTS 4 and
92. Remember to
and