Table of Contents
Advertisement
7.4.1.1.2
Reinstalling the RX Splitter
This procedure describes how to reinstall the RX Splitter.
Procedure:
1 Fasten the RX Splitter onto the bracket.
2 Slide the RX Splitter into the cabinet.
3 Tighten the two fastening screws at the front.
4 Connect the RX cables to the back of the RX Splitter.
5 Slide on the top rear and front panels and fasten these with screws.
6 Place the front panel back on and screw this into place.
7 Put the door of the cabinet back on.
7.4.2
Cavity Combiner
See
Cavity Combiner on page
283.
Chapter 7: Radio Frequency Distribution System
6802800U74-AN
293
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
