Figure 191: Procedure 1 Troubleshooting Flowchart
13.2.1.5
Reported/Suspected Problems
Use Procedure 2 to troubleshoot reported or suspected equipment malfunctions. Perform this
procedure with equipment in service (non-intrusive) and with equipment taken temporarily out of
service (intrusive).
ROUTINE
SITE VISIT
OBSERVE LED
INDICATORS
Refer to
Controls and Indicators
for LED Definitions
Yes
Module Suspected
of Being Faulty?
No
CHECK CURRENT
ALARM STATUS
Use MMI command
get alarms
to check alarm status
Yes
Module Suspected
of Being Faulty?
No
DONE
Chapter 13: MTS Troubleshooting
PROCEDURE 1
Go to Troubleshooting
Procedure 2 Flow Chart
Go to Troubleshooting
Procedure 2 Flow Chart
EBTS021
071895JNM
6802800U74-AN
393