Table of Contents
Advertisement
6802800U74-AN
Chapter 15: Expansion Options
15.5.3
Configuration
When the new Cavity Combiner has been installed, the mapping list needs to be updated with the new
TrackID. For more information, see
15.6
Hybrid Combiner Expansion
It is possible to expand the MTS 4 with additional Hybrid Combiner.
NOTICE: The additional Hybrid Combiner is delivered with the expansion kit that includes
required equipment and cables.
15.6.1
Installing an additional Hybrid Combiner
Follow the instructions below to install the additional Hybrid Combiner.
Procedure:
1 Switch OFF the Power Supply Unit.
2 Assemble the Bracket with the three M6x10 screws.
3 Fasten the two M4x10 screws that are to hold the Hybrid Combiner but do not tighten them fully.
4 Place the Hybrid Combiner on the bracket of the cabinet with the heat sink facing the side of the
cabinet.
5 Slide the Hybrid Combiner at an angle ensuring that the lip at the back of the Hybrid Combiner is
secured behind the bracket.
6 Tighten the two M4x10 screws to the bracket.
7 Attach the TX and antenna cables.
8 Switch ON the Power Supply Unit.
15.6.2
Configuration
No further configuration is needed when having installed the Hybrid Combiner.
15.7
Expansion from MTS 2 to MTS 4 Cabinet
It is possible to expand from an existing MTS 2 to MTS 4.
NOTICE: When expanding from MTS 2 to MTS 4, an additional Base Radio is delivered with
the expansion kit that includes required equipment and cables.
440
Updating the Mapping List with the New TrackID on page
286.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
