Logging On To The Base Radio Application Through Serial Connection; Logging On To The Boot1 Mode - Motorola MTS LiTE Installation, Configuration And Basic Service Manual

6802800U74-AN
Chapter 6: Configuration and Testing
• Data Bits: 8
• Stop Bits: 1
• Handshaking: none
• Parity: none
4 Establish connection by selecting Connection → Connect Direct.
5 Log on to the Site Controller application by entering the username and password.
The Site Controller application prompt appears:
SC:
6.2.1.2

Logging on to the Base Radio Application through Serial Connection

Prerequisites: Ensure the Base Radio is connected to the Site Controller.
Procedure:
1 Connect the port RS232 of the Service Terminal with the Base Radio RJ45 Service Port using
the Service Cable.
See Service Cable and Connector Box Description on page 227
Service Cable.
2 On the Service Terminal start the BTS Service Software application, select the proper MTS type
and log on.
3 In the Configuration → Direct Settings → Direct Serial Port Settings menu, verify the correct
settings:
• Port: The appropriate serial port is selected.
Speed: 19200 baud
•
Data Bits: 8
•
• Stop Bits: 1
• Handshaking: none
• Parity: none
4 Establish connection by selecting Connection → Connect Direct.
5 Log on to the Base Radio application by entering the username and the password.
The Base Radio application prompt appears:
BR)
6.2.1.3

Logging on to the BOOT1 mode

BOOT1 is the second stage bootloader in the BR-Arch-1 architecture. Use this mode to start other
applications (for example the Test Application), and set the basic Base Radio configuration.
Procedure:
1 Log on to Site Controller application or Base Radio application, depending on which application
you need to use.
See Logging on to the Site Controller Application through Serial Connection on page 223
Logging on to the Base Radio Application through Serial Connection on page
224
for more information about the
224.
or