6802800U74-AN
Chapter 6: Configuration and Testing
Figure 132: BRC Indicators
6.5.2
Base Radio Position and Receivers Selection
The new Base Radio needs to be assigned a position identifier. This operation is performed from the
Service port.
Use the MMI commands to:
•
Set the position identifier of the Base Radio within the cabinet. See
Radio Position by Using the cccp Command on page
•
Set the number of active receivers (diversity) of the new Base Radio. See
Receiver Branches on page
•
BR-Arch-1 Base Radios only: Verify and configure additional receiver parameters. See
Receiver Configuration for BR-Arch-1 on page
For detailed information on the MMI commands, see the MTS Man Machine Interface Commands
Manual.
236
BASE RADIO
FRONT VIEW
BASE RADIO
DC in
Tx
Service
SC1
SC2
239.
239.
Rx 1
Rx 2
Rx 3
Reset
TX
AUX
Status
BR
Alarm
Setting and Accessing Base
237.
Enabling Base Radio
Additional