Table 79: Corrective Actions For Missing Or Bad Base Radio Parameters In Br-Arch-1 Architecture - Motorola MTS LiTE Installation, Configuration And Basic Service Manual

6802800U74-AN
Chapter 6: Configuration and Testing
get nvm_param rx1 atten_default
The correct setting should be 0 for MTS 4 and 4 for MTS 2. If the command does not return any
parameter value, then the parameter is missing. See
Bad Base Radio Parameters in BR-Arch-1 Architecture on page 240
3 Enter:
get nvm_param pa dekey_limit
The correct setting should be 26. If the command does not return any parameter value, then the
parameter is missing. See
Parameters in BR-Arch-1 Architecture on page 240
4 Enter:
get nvm_param rx1 rx_dc_inj_usl
The correct setting should be 2.5. If the command does not return any parameter value, then
the parameter is missing. See
Parameters in BR-Arch-1 Architecture on page 240
5 Enter:
get nvm_param rx1 rx_dc_inj_lsl
The correct setting should be 0. If the command does not return any parameter value, then the
parameter is missing. See
Parameters in BR-Arch-1 Architecture on page 240
6 Enter:
get nvm_param rx1 ad1_scaling6
The correct setting should be 28.9. If the command does not return any parameter value, then
the parameter is missing. See
Parameters in BR-Arch-1 Architecture on page 240
7 Enter:
get nvm_param rx1 rx_fru_config
The setting will depend on the receiver diversity required for the site. If the command does not
return any parameter value, then the parameter is missing. See
Missing or Bad Base Radio Parameters in BR-Arch-1 Architecture on page 240
parameter.
Postrequisites:
After updating the parameters, enter: reset and then enter: y for the configuration changes to take
effect.
6.5.2.3.1.1
Corrective Actions for the BR-Arch-1 Base Radio Receiver Configuration
NOTICE: Use corrective actions only for Base Radio receivers in BR-Arch-1 configuration.

Table 79: Corrective Actions for Missing or Bad Base Radio Parameters in BR-Arch-1 Architecture

Missing or Bad Pa-
rameter
atten_default
240
Table 79: Corrective Actions for Missing or Bad Base Radio
Table 79: Corrective Actions for Missing or Bad Base Radio
Table 79: Corrective Actions for Missing or Bad Base Radio
Table 79: Corrective Actions for Missing or Bad Base Radio
Corrective Action
• For MTS 4, enter:
Table 79: Corrective Actions for Missing or
to add the parameter.
to add the parameter.
to add the parameter.
to add the parameter.
to add the parameter.
Table 79: Corrective Actions for
to add the