Cabinet Bracing Considerations; Floor Mounting Instructions; Installing The Cabinet Using The Mounting Brackets; Figure 16: Mts - Mounting Brackets - Motorola MTS LiTE Installation, Configuration And Basic Service Manual

4.4.1

Cabinet Bracing Considerations

The MTS cabinet is self-supporting. In seismically active areas, additional bracing of the cabinet could
be required. However, the bracing hardware must be locally procured.
NOTICE: There are no specific procedures within this manual for bracing cabinets in active
seismic areas.
4.4.2

Floor Mounting Instructions

The MTS LiTE, MTS 2, MTS 4, and Expansion Cabinets can be mounted directly to the floor using the
mounting brackets, see Figure 16: MTS – Mounting Brackets on page
NOTICE: The floor mounting brackets are not part of standard MTS shipment. If floor mounting
brackets are to be used, they must be ordered as an accessory.
Partnumber 01015026001 STANDARD FLOOR MOUNT SET MTS
Figure 16: MTS – Mounting Brackets
4.4.3

Installing the Cabinet Using the Mounting Brackets

When and where to use: Perform this procedure to properly install the cabinet within the site facility
using the mounting brackets.
Procedure:
1 Check that the mounting brackets have been correctly positioned in the equipment room, see
Figure 6: Suggested MTS LiTE Site Layout on page 65
2 Site Layout on page 66
MTS 4, and Figure 12: Suggested Expansion Cabinet Site Layout on page 70
Cabinet site.
for MTS 2, Figure 10: Suggested MTS 4 Site Layout on page 68
Chapter 4: Hardware Installation
91.
for MTS LiTE, Figure 8: Suggested MTS
for Expansion
6802800U74-AN
for
91