Appendix D: Assembling The Gnss Antenna; Figure 214: Gnss Antenna Assembly - Exploded View; Figure 215: Gnss Antenna Assembly - Cable - Motorola MTS LiTE Installation, Configuration And Basic Service Manual

6802800U74-AN

Appendix D: Assembling the GNSS Antenna

Appendix D
Assembling the GNSS Antenna
Perform this procedure to assemble a GNSS antenna.
The following figure presents the exploded view of the GNSS antenna.

Figure 214: GNSS Antenna Assembly - Exploded View

GNSS Antenna Assembly
1/4"-20 UNC-3A X 1" Set Screw
The following part numbers are valid for the relevant elements:
GNSS Antenna Assembly
PMLN7532A
Collar Bracket
BR000247A01
GPS Antenna/Receiver to Site Controller Cable
3066564B, <CL>, where <CL> is the cable length code of 01, 02, or 03, meaning 40, 150, or 600
meters of cable length, respectively.
Prerequisites: Verify that you have the Allen wrench (included in the set), a T30 screwdriver, and a
Phillips screwdriver.
Procedure:
1 Run the digital cable through the steel pipe and collar bracket. Attach the digital cable connector
to bottom of the antenna module (male to female Deutsch connector).
Figure 215: GNSS Antenna Assembly – Cable
2 Align four bracket screw holes with the GNSS antenna bottom mounting holes and screw the
collar bracket to the bottom of the antenna module using a Phillips screwdriver.
462
M5 Screw
Collar Bracket
1-1/2" O.D. Galvanized Steel Pipe
GPS Antenna/Receiver
to Site Controller Cable