6802800U74-AN
Chapter 7: Radio Frequency Distribution System
Figure 163: Schematic Diagram of RX Splitter
Splitter
7.4.1.1
Replacing the Expansion Cabinet RX Splitter
This process outlines the recommended tasks to be performed to replace the Expansion Cabinet RX
Splitter. For a list of available FRUs, see
Process:
1 Remove the RX splitter, see
2 Reinstall the RX splitter, see
7.4.1.1.1
Removing the RX Splitter
This procedure describes how to remove the RX Splitter.
Procedure:
1 Remove the door of the cabinet completely.
2 Remove the four screws holding the front panel.
3 Loosen the two screws holding the front section of the top panel and slide off the panel.
4 Loosen the screws fastening the rear section of the top panel and slide off the panel.
5 Remove the RX cables connected to the back of the RX Splitter.
6 Loosen the two fastening screws at the front enough to free the mounting bracket.
7 Slide the RX Splitter out of the cabinet.
8 Remove the RX Splitter from the bracket and replace with the new unit.
292
Field Replaceable Units (FRUs) on page
Removing the RX Splitter on page
Reinstalling the RX Splitter on page
DC
RX
BR5
brick
DC
BR6
RX
brick
DC
RX
BR7
brick
DC
RX
BR8
brick
RX
Prime
net
Cabi
446.
292.
293.