Table of Contents
Advertisement
Figure 5-1 Check USB Equipment Resource
4. Communication test
Open USB control terminal of upper computer SARemote-
Control by double-clicking. By "View--> SCPI instruction",
open remote command control panel, and then you can send
command and read data through this panel, as shown in the
following:
SCPI Instruction:
Equipment：*idn?
Equipment：Company,UTS1000,SN200001001,V2.6.4.1
Figure 5-2 Read/write Command by USB
5.2 By LAN
1. Connect equipment
Connect spectrum analyzer to your LAN through LAN
interface.
2. Communication test
Open LAN control terminal of upper computer SARemote-
76
Control by double-clicking. Open remote command control
panel, and then you can send command and read data
through this panel, as shown in the following:
SCPI Instruction:
Equipment：*idn?
Equipment：Company,UTS1000,SN200001001,V2.6.4.1
Figure 5-3: Send Command and Read Data by panel
6 Troubleshooting and Maintenance
This chapter lists possible common troubleshooting during
Send
Clear
the use of spectrum analyzer.
Contents are as follows:
Black screen and without any display after start-up
No response or error of key value by pressing keys
No signal displayed after normal start-up
Signal frequency inaccurately displayed
Signal amplitude inaccurately displayed
6.1 Troubleshooting
1. Black screen and without any display after start-up
Send
Clear
Advertisement
Table of Contents
