Table of Contents
Advertisement
Uni-Trend Technology (Chengdu) Ltd
6.
On the virtual control panel in Fig 3-4, you can operate your oscilloscope with different buttons as
instructed by the oscilloscope operating manual.
7. When operation is complete press [QUIT] to close this screen.
Note : The "data transmission", and "Far control" functions cannot be operated simultaneously.
3.2 Ethernet (LAN) interface controls
The Ethernet port is a dedicated interface module of UTD4000 Series Digital Storage Oscilloscopes. This
TCP/IP protocol embedded module can provide direct Ethernet connection to a UTD4000 series
oscilloscope. After installing the communication and control software, you can operate your oscilloscope
on remote control through LAN or the Internet. As it supports concurrent visit by multiple users, there are
no geographical and users restraints and you can carry out network and remote testing as well as
measuring.
With the optional UT-M06 Ethernet module, you can operate the oscilloscope through the LAN interface
as follows :
1.
Select "LAN" in the equipment selection option on the real-time control panel.
2.
When "LAN" is selected, the dialog box in Fig 3-5 will pop up.
Enter the DSO IP address in this box. The IP addresses set in the software and the communicated
oscilloscope must be the same, otherwise communication between the oscilloscope and the software
cannot be established.
Please refer to the oscilloscope operating manual for operation instructions. Access sub-menu page 2 by
pressing [UTILITY] → LAN on the oscilloscope control panel for TCP/IP protocol setup. You should set
up the IP address, netmask and default gateway in LAN. In the same network, the IP address of every
individual digital storage oscilloscope is unique and must not conflict with the IP address of any other
equipment (in-network IP addresses).
3. For other operation instructions refer to steps 2, 3, 4, 5, 6 and 7 for "USB interface controls" in this
chapter.
Note : When using the LAN interface, you can operate the oscilloscope by remote control via LAN or
the Internet. Mapping feature of the router must be enabled and the public network address of your
company should provided.
UTD4000 Digital storage oscilloscope communication control software Operating Manual and Installation Guide
Fig 3-5
Page 23 of 27
Advertisement
Table of Contents
