UNI-T UTS1000 Series Operating Manual page 53

3.3.8.37 [Rising edge]
Set trigger as external rising-edge trigger.
3.3.8.38 [Falling edge]
Set trigger as external falling-edge trigger.
3.3.8.39 [Pass -Fail ] [Pass-Fail
Soft menu of pass/fail measurement function pops up.
Pass/ fail measurement has two modes: window
measurement and region measurement.
3.3.8.40 [Window measurement ]
S
oft menu of window measurement mode pops up.
3.3.8.41 [Window measurement On Off]
Open or close window measurement mode.
3.3.8.42 [Amplitude line On Off]
Enable or disable amplitude line. This amplitude line
defaults to on when window measurement is on.
3.3.8.43 [Frequency line On Off]
Enable or disable frequency line. This frequency line
defaults to on when window measurement is on.
50
3.3.8.44 [Window sweep On Off]
Enable or disable window sweep. When window sweep is
on, only sweep within window formed by the intersection
of amplitude line and frequency line, periphery is not
swept; when window sweep is off, sweep in full frequency
range.
]
3.3.8.45 [Amplitude/frequenc
It is used to sweep and edit amplitude line's upper limit
line and lower limit line, frequency line's start frequency
and stop frequency.
3.3.8.46 [Region measurement ]
Soft menu of region measurement mode pops up.
3.3.8.47 [Region measurement On Off]
Open or close region measurement mode.
3.3.8.48 [Upper limit line On Off]
Enable or disable upper limit line. When region
measurement is on, upper limit line defaults to on.