UNI-T UTS1000 Series Operating Manual page 33

Table 3-1 Descriptions of Basic Functions (continued)
Function key Access key
[Editoflower
[Edit ]
Soft menu for the edit of lower line pops up.
line ]
Move frequency marker at the peak of track,
PEAK ——
and soft menu related with frequency marker
function pops up.
[Max.valuesearch]
PEAK Move frequency marker at the peak of track.
Move active frequency marker to next highest
[Next peak] PEAK peak of track related with position of current
frequency marker.
Move frequency marker to the peak on the left
[Left peak]
PEAK
of current frequency marker.
Move frequency marker to the peak on the
[Right peak]
PEAK
right of current frequency marker.
[Frequency
Set peak frequency marker moving to center
PEAK
marke center
frequency.
frequency]
Look up min. amplitude value on the trace,
[Min.valuesearch]
PEAK
and mark it by marker.
Enable or disable signal tracking function,
[Peak search]
frequency marker always tracks max. value
PEAK
On Off
of current trace.
Activate frequency span, set spectrum
——
SPAN analyzer in center frequency span mode, and
soft menu for the setting of span pops up.
Activate frequency span function, set
[Span] spectrum analyzer in center frequency span
SPAN
mode.
30
Descriptions
[Previous span]
information ]
[Localnetwork ]
[Subnet mask]
Set spectrum analyzer's span value as
[Full span]
SPAN
maximum value.
Set span as 0Hz, this function displays input
[Zero span]
signal in amplitude-time mode, so it is very
SPAN
helpful to observe modulated signal.
Set spectrum analyzer's span value as
SPAN
previous span value.
——
SYS
Soft menu about system setting pops up.
Open soft menu of system information and
[System
SYS
system log.
[System [System Open relevant parameters concerning system
information] information ]
information.
Open system log to view system revision
[System
[System log]
information ] records.
[Local
Enter soft menu of language setting.
SYS
language ]
[Local
[Chinese]
System is displayed in Chinese.
language ]
[Local
[English]
System is displayed in English.
language ]
[Date/time ]
SYS Enter soft menu of date and time setting.
[Date setting] [Date/time ]
Set system date.
[Time setting] [Date/time ]
Set system time.
Open soft menu for the setting of local
SYS
network parameters.
[IP address] [Localnetwork ] Set host computer's IP address.
[Localnetwork ] Set subnet mask parameters.
[Gateway] [Localnetwork ] Set gateway parameters.