Advertisement
Quick Links
Advertisement
Related Manuals for UNI-T UT310 Series
Summary of Contents for UNI-T UT310 Series
- Page 1 P/N:110401103773X DATE:2018.06.26 REV.2...
- Page 2 CONTENTS Introduction to UT312 Product----------------------------------------------------------------------------1 II. Unpacking Inspection---------------------------------------------------------------------------------------2 III. Safety Notices------------------------------------------------------------------------------------------------ 2 IV. Instrument Structure----------------------------------------------------------------------------------------3 V. Instrument Setup and Operation-------------------------------------------------------------------------4 VI. Technical Indicators-----------------------------------------------------------------------------------------6 VII. Maintenance--------------------------------------------------------------------------------------------------7...
- Page 3 II.UNPACKING INSPECTION I.INTRODUCTION TO UT312 PRODUCT Please unpack and check if following items are deficient or damaged or not. Please contact UT-312 vibration meter is a split portable vibration measurer which consists of acceleration the nearest sales service agent of our company if there is any deficiency or damage. sensor and digital measurement display circuit.
- Page 4 Please do not detach shell of vibration meter to avoid damage. three-gear toggle switch signal wire of sensor Please do not try to charge battery to avoid personal injury due to battery explosion. Please sensor shell pay attention to poles during battery installation. measurement key Please pay attention to protect LCD of vibration meter to avoid scratch or crush.
- Page 5 VI.TECHNICAL INDICATORS 2.Power Inspection Please press measurement key and observe display. Battery replacement mark in the left end 1. General Specification of display shows low battery voltage and prompt of battery replacement. No mark refers to LCD display: 3 1/2-bit display; The maximum display: 1999 normal voltage for measurement.
- Page 6 Vibration measurement scope 2. General Maintenance Please inspect signal wires of sensor constantly because instrument may not display due to Vibration Vibration Vibration Measurement unit damage or poor contact of such wires. It is not allowed to pull or drag signal wires forcefully. acceleration (O-P) speed (RMS) displacement (P-P)