Supported Operating Systems; Configuring Tcp/Ip - Xerox 6110MFP/XN Service Documentation

Supported operating systems

The following table shows the network environments supported by the machine:
TCP/IP: Transmission Control Protocol/Internet Protocol
IPP: Internet Printing Protocol
SNMP: Simple Network Management Protocol
DHCP: Dynamic Host Configuration Protocol
BOOTP: Bootstrap Protocol

Configuring TCP/IP

Your machine can be set up with a variety of TCP/IP network information, such as an IP address, a subnet
mask, a gateway, and DNS addresses.
There are several ways in which your machine can be assigned a TCP/IP address, depending on your net-
work.
Static addressing: A TCP/IP address is assigned manually by the system administrator.
Dynamic addressing via BOOTP/DHCP (default): A TCP/IP address is assigned automatically by the
server.
Note : Before configuring TCP/IP, you need to set the network protocol to TCP/IP.
Static addressing
To enter a TCP/IP address from your machine's control panel, take the following steps:
1. Press Menu until Network appears on the bottom line of the display and press OK.
2. Press OK when TCP/IP appears.
3. Press the Scroll buttons until Static appears and press OK.
4. Press OK when IP Address appears.
5. Enter a byte between 0 and 255 using the number keypad and press the Scroll buttons to move between
bytes.
Repeat this to complete the address from the 1st byte to the 4th byte.
6. When you have finished, press OK.
7. Repeat steps 5 and 6 to configure the other TCP/IP parameters:
subnet mask and gateway address.
8. Press the Scroll buttons until Primary DNS appears and press OK.