Cabling - Planet IGS-5225 Series User Manual

2.3 Cabling

10/100/1000BASE-T

All 10/100/1000BASE-T ports come with auto-negotiation capability. They automatically support 1000BASE-T,
100BASE-TX and 10 BASE-T networks. Users only need t o plug a w orking network device into one of the
10/100/1000BASE-T ports, and then turn on the Industrial Managed Switch. The port will automatically run at 10Mbps,
20Mbps, 100Mbps or 200Mbps and 1000Mbps or 2000Mbps after negotiating with the connected device.
100BASE-FX/1000BASE-SX/LX

The Industrial Managed Switch has four SFP interfaces that support 100/1000Mbps dual speed mode (optional
multi-mode/single-mode 100BASE-FX/1000BASE-SX/LX SFP module)
Cabling

Each 10/100/1000BASE-T port uses an RJ45 socket -- similar to phone jacks -- for connection of unshielded twisted-pair
cable (UTP). The IEEE 802.3/802.3u 802.3ab Fast/Gigabit Ethernet standard requires Category 5 U TP for 100Mbps
100BASE-TX. 10BASE-T networks can use Cat.3, 4, 5 or 1000BASE-T use 5/5e/6 UTP (see table below). Maximum
distance is 100 meters (328 feet). The 100BASE-FX/1000BASE-SX/LX SFP slot uses an LC connector with optional SFP
module. Please see table below and know more about the cable specifications.
Port Type
10BASE-T Cat3, 4, 5, 2-pair
100BASE-TX Cat5 UTP, 2-pair
1000BASE-T Cat5/5e/6 UTP, 2-pair
100BASE-FX
50/125µm or 62.5/125µm multi-mode 9/125µm single-mode
1000BASE-SX/LX 50/125µm or 62.5/125µm multi-mode 9/125µm single-mode
10GBASE-SR/LR 50/125µm or 62.5/125µm multi-mode 9/125µm single-mode
Any Ethernet devices like hubs and PCs can connect to the Industrial Managed Switch by using straight-through wires.
The two 10/100/1000Mbps ports are auto-MDI/MDI-X and can be used on straight-through or crossover cable.
Cable Type
62
User's Manual of IGS-5225 series
Connector
RJ45
RJ45
RJ45
LC (multi/single mode)
LC (multi/single mode)
LC (multi/single mode)