Planet IGS-5225 Series User Manual page 356

• Clear
• Port
• Users
• Violation Mode
• State
• MAC Count
(Current, Limit)
Buttons
Auto-refresh : Check this box to refresh the page automatically. Automatic refresh occurs every 3 seconds.
: Click to refresh the page immediately.
Click to remove all MAC addresses on all VLANs on this port. The button is only
clickable if number of secured MAC addresses is non-zero.
The port number for which the status applies. Click the port number to see the
status for this particular port.
Each of the user modules has a column that shows whether that module has
enabled Port Security or not. A '-' means that the corresponding user module is
not enabled, whereas a letter indicates that the user module abbreviated by that
letter has enabled port security.
Shows the configured Violation Mode of the port. It can take one of four values:
Disabled: Port Security is not administratively enabled on this port.
Protect: Port Security is administratively enabled in Protect mode.
Restrict: Port Security is administratively enabled in Restrict mode.
Shutdown: Port Security is administratively enabled in Shutdown mode.
Shows the current state of the port. It can take one of four values:
Disabled: No user modules are currently using the Port Security service.

Ready: The Port Security service is in use by at least one user module, and

is awaiting frames from unknown MAC addresses to arrive.
Limit Reached: The Port Security service is enabled by at least the Limit

Control user module, and that module has indicated that the limit is reached
and no more MAC addresses should be taken in.
Shutdown: The Port Security service is enabled by at least the Limit Control

user module, and that module has indicated that the limit is exceeded. No
MAC addresses can be learned on the port until it is administratively
re-opened on the Limit Control configuration web page.
The two columns indicate the number of currently learned MAC addresses
(forwarding as well as blocked) and the maximum number of MAC addresses
that can be learned on the port, respectively.
If no user modules are enabled on the port, the Current column will show a dash
(-).
If the Limit Control user module is not enabled on the port, the Limit column will
show a dash (-).
356
User's Manual of IGS-5225 series