Planet IGS-5225 Series User Manual page 150

The page includes the following fields:
Object
• Session
Mode
•
• Type
• VLAN ID
• Reflector Port
• Source VLAN(s)
Configuration
Remote Mirroring
•
Port Configuration
Description
Select session id to configure.
To Enabled/Disabled the mirror or Remote Mirroring function
Mirror
The switch is running on mirror mode.
The source port(s)
Source
The switch is a source node for monitor flow.
The source port(s),
RMirror destination
The switch is an end node for monitor flow.
The destination port(s)
The VLAN ID points out where the monitor packet will copy to. The default VLAN ID is
200.
The reflector port is a method to redirect the traffic to Remote Mirroring VLAN. Any device
connected to a port set as a reflector port loses connectivity until the Remote Mirroring is
disabled.
In the stacking mode, you need to select switch ID to select the correct device.
If you shut down a port, it cannot be a candidate for reflector port.
If you shut down the port which is a reflector port, the remote mirror function cannot work
The switch can supports VLAN-based Mirroring. If you want to monitor some VLANs on
the switch, you can set the selected VLANs on this field.
The following table is used for port role selecting.
Port: The logical port for the settings contained in the same row..
■
Source: Select mirror mode.
■
Disabled Neither frames transmitted nor frames received are mirrored.
Both Frames received and frames transmitted are mirrored on the Destination
port.
Rx only Frames received on this port are mirrored on the Destination port.
Frames transmitted are not mirrored.
Tx only Frames transmitted on this port are mirrored on the Destination port.
Frames received are not mirrored
Destination: Select destination port.
■
This checkbox is designed for mirror or Remote Mirroring.
150
User's Manual of IGS-5225 series
and destination port are located on this switch.
reflector port are located on this switch.
is located on this switch.