Table of Contents
Advertisement
2.5 Cabling
100Base-TX and 100Base-FX
The 10/100Mbps RJ-45 ports come with Auto-Negotiation capability. Users only need to plug in working network
device into one of the 10/100Mbps RJ-45 ports. The ISW-504PS / ISW-514PS series will automatically run in 10Mbps
or 100Mbps after the negotiation with the connected device. The ISW-514PS has one 100Base-FX SC Interface
(Multi-mode, 50/125μm or 62.5/125μm fiber cable and the available distance is 2km). The ISW-514PS15 has one
100Base-FX SC Interface (Single-mode, 9 / 125μm fiber cable and the available distance is 15km). The ISW-514PSF
has one 100Base-FX SFP interface (Optional Multi-mode / Single-mode 100Base-FX SFP module)
Cabling
Each 10/100Base-TX ports use RJ-45 sockets -- for connection of unshielded twisted-pair cable (UTP).
The 100Base-FX port is uses as SC / LC connector. Please see table below and know more about the cable's
specification.
Port Type
10Base-T
100Base-TX
100Base-FX
100Base-FX
100Base-FX
Any Ethernet devices like Hubs / PCs can connect to the Industrial PoE Switch by using straight-through wires. The
10/100Mbps RJ-45 ports are auto-MDI / MDI-X can be used on straight-through or crossover cable.
2.5.1 Installing the SFP transceiver (ISW-514PSF Only)
The sections describe how to insert an SFP transceiver into an SFP slot.
The SFP transceivers are hot-pluggable and hot-swappable. You can plug-in and out the transceiver to/from any SFP port
without having to power down the Switch/Media Converter. As the Figure 2-6 appears.
Cable Type
Cat 3, 4, 5, 2-pair
Cat.5, 5e, 6 UTP, 2-pair
50 / 125μm or 62.5/125μm
9 / 125μm
50 / 125µm or 62.5 / 125µm multi-mode
9 / 125µm single-mode
-21 -
Connector
RJ-45
RJ-45
SC (Multi-mode)
SC (Single-mode)
LC (Multi / Single mode)
User's Manual
Advertisement
Table of Contents
