Cabling; Status Leds; The Rear Panel; Power Connector - Planet FNSW-1601 User Manual

2.2.2 Cabling

Fast Ethernet Switch 100Base-TX ports use RJ-45 sockets -- similar to phone jacks -
- for connection of unshielded twisted-pair cable (UTP). The IEEE 802.3u Fast Ethernet
standard requires Category 5 UTP for 100Mbps 100Base-TX. 10Base-T networks can use
Cat.3, 4, or 5 UTP (see table A)
Port Type
10Base-T
100Base-TX

2.2.3 Status LEDs

One green LED to show power On/Off is on the front panel. Also, each port has three
status LED indicators, as shown below.
PWR This indicator lights green when the Switch is receiving
power, otherwise, it is off.
LNK/ACT This indicator light green when the port is connected to an
Ethernet or Fast Ethernet station, if the indicator is blink-
ing green, it will be transmitting or receiving data on the
network.
100 This LED indicator light orange when a Fast Ethernet sta-
tion is connected. It remains OFF, if an Ethernet station is
connected.

2.3 The Rear Panel

2.3.1 Power Connector

The Power Connector is designed to be used with the power cord included in the product
package. Attach the female end of the cord to the power connector and the male end
of the cord to a grounded power outlet. The accepted power range is from 100VAC to
240VAC, 50/60Hz.
Note:
The Switch is a power-required device, it means, the Switch will not work
until it is powered. If your networked PCs will need to transmit data all the
4
Cable Type
Cat 3, 4, 5
Cat.5/5e UTP
Table A: Supported port list
Table B: The Switch's Port-LED Functions
Figure 3: Rear View for the Switch
Connector
RJ-45
RJ-45