Avaya 8800 Installation Manual page 49

rate optical transceivers that support LAN applications. For a list of Avaya-qualified SFPs, SFP
+s and XFPs, see
Important:
The 8812XL supports only Avaya-qualified 10Gbps SFP+ transceivers. 1Gbps transceivers
are not supported.
For example, if you insert a 1G transceiver into a 10G port on the 8812XL, the port is
prevented from coming online and the system displays the following message on the
console. This is true even if the inserted part is Avaya-qualified.
CPU# [date time] COP-SW INFO Slot #: 1G SFP detected in 10G SFP+
port #. Port offline.
Important:
The 8812XL module requires, at minimum, software release 7.1.3 to operate properly.
The following figure shows the 8812XL SFP+ I/O module.
Figure 18: 8812XL SFP+ I/O module
The following figure shows the LED locations. The Port Status LEDs are below the port number
label.
Figure 19: 8812XL SFP+ I/O module LED locations
The following table describes the 8812XL SFP+ I/O module LEDs.
Table 12: 8812XLmodule LEDs
Type
Port
Installation — Modules
Avaya-qualified SFPs, SFP+s and XFPs
Label Color, State
Port status Green, Steady
(no label)
Green, Slow blinking
Interface module descriptions
on page 57.
Meaning
The port is connected and linked,
but no data flow occurs.
The port is administratively
disabled.
October 2014 49