Connecting A Pc Or Terminal To The Sf/Cpu - Avaya 8800 Installation Manual

6. Install the #2-56 x .188 screws.
7. Replace the 8692SF/CPU (with the newly installed CPU daughter card attached)

Connecting a PC or terminal to the SF/CPU

To establish a local CLI, ACLI, or Enterprise Device Manager session to the Avaya Ethernet
Routing Switch 8800/8600, connect a PC or a VT-100 terminal to the console port on the
8692SF/CPU or the 8895SF/CPU module.
Prerequisites
• You require a serial console cable with a 9-pin receptacle connector.
Procedure steps
1. Turn on and configure the terminal or a communications port on the PC using the
Installation — Modules
Insert the shorter screws into the oval holes in the sheet metal mezzanine card
bracket, not through the mezzanine card.
into the vacant chassis slot.
parameters in the following table.
See the PC or terminal user manual for instructions.
Connecting a PC or terminal to the SF/CPU
October 2014 95