Table of Contents
Advertisement
2. WIRING
2.3
Trackball Control Unit
Connect the control unit cable to the processor unit (J1 or J2). To use the USB port on
the trackball control unit, connect the unit to either one of the LAN ports on the proces-
sor unit, using the supplied USB cable (TS-20-071-1). Note that the trackball control
unit cannot be operated if only a USB cable is connected on the processor unit. If the
USB port on the trackball control unit will not be used, the USB connection between
the trackball control unit and processor unit is not required.
Connect a ground wire (IV-1.25sq., local supply) between the ground terminal and
ship's ground.
Cable tie mount
Fasten the USB cable using
the supplied cable tie.
Note 1: If the USB cable is connected to the trackball control unit, fasten the USB ca-
ble to the cable tie mount using the supplied cable tie.
Note 2: The maximum cable length for USB2.0 is 5 m. To extend the USB cable, the
optional DVI/USB repeater is required. If you extend the USB cable without the DVI/
USB repeater, the USB device operation is not guaranteed.
Note 3: The supplied USB cable and USB port on the trackball control unit do not sup-
port USB3.0. The USB port on the trackball control unit is available, even if the sup-
plied USB cable is connected to USB3.0 port on the processor unit. However, the data
transfer speed is equivalent to USB 2.0.
Note 4: If the USB cable will not be connected to the trackball control unit, attach the
supplied USB sheet to the USB port on the trackball control unit.
2-10
Ground terminal
Fasten a ground wire (IV-1.25sq.,
local supply).
Control unit cable
USB cable (TS-20-071-1, 5 m
Connect with either one of the USB ports on the
processor unit.
USB sheet:
Attach this sheet when the USB cable
between the trackball control unit and
processor unit is not used.
Connect with the processor
unit (J1 or J2).
Hide quick links:
Advertisement
Table of Contents
