Table of Contents
Advertisement
Menu item
[External IDENTI-FISH Echo
*1, *2
Window]
*1
[Date Auto Adjust]
*1
[Date Setting]
*1
[Time Setting]
*1, *2
[Time Zone]
[Bottom Search]
[TX Triggering]
[In Trigger]
[Trigger Input]
Description
To display the IDENTI-FISH
monitor, select [On]. When [Off] is selected, you can
drag the graph window, etc. to the sub monitor.
Echoes are not displayed on the sub monitor.
Note: To change this setting item, reset the mode set-
tings to the factory default. The following message ap-
pears. Click the [Yes] button to reset the mode settings.
For details about the mode settings, see the operator's
manual.
Changes made to the External IDENTI-FISH Echo Window will
reset the mode settings to default.
Select [On] to adjust the system time automatically ac-
cording to the data from the navigation equipment. Select
[Off] to set the system time manually.
Click the
button to open the [Date Setting] window.
Enter the appropriate date for the system time, then click
the [OK] button. This menu item is enabled when [Date
Auto Adjust] is set to [Off].
Click the
button to open the [Time Setting] window.
Enter the appropriate time for the system time, then click
the [OK] button. This menu item is enabled when [Date
Auto Adjust] is set to [Off].
Select the appropriate time zone from the pull-down list.
Not used at installation.
Select [On] to synchronize the KP (Keying Pulse) signal
from the external equipment that is connected to the
TRIG-I/O port on the transceiver unit.
Select the reaction to a KP signal that is input from the
external equipment. This menu item is enabled when [In
Trigger] is set to [On].
• [↑]: Operates in response to the detection of a rising
edge.
• [↓]: Operates in response to the detection of a falling
edge.
3. INITIAL SETTINGS
™
echo window on the sub
Attention
Are you sure?
Yes
No
Date Setting
OK
Cancel
Time Setting
OK
Cancel
3-7
Hide quick links:
Advertisement
Table of Contents
