Furuno FSS-3BB Installation Manual page 46

3. INITIAL SETTINGS
6. Set the menu items, referring to the following table.
Menu item
[NMEA Format]
[Output Data]
[TLL Output]
[Echo Start Depth]
[Output Echo Cycle]
[Echo Resolution]
[Manual]
[Echo Data Format]
[Baud Rate]
*: These output data require appropriate external data input.
7. Click the [OK] button to close the port setting menu.
8. Click the [Close] button (
3-12
Select a NMEA format among Ver 1.5, Ver 2.0, Ver 3.0,
Echo.
Note 1: When the NMEA format is changed, the defaults
settings are restored for the items in the same window.
Note 2: The [Echo] setting is intended for use by research-
ers. Do not select the setting unless applicable. The NMEA
outputs echo data (baud rate: 38400, 57600 or 115200 bps),
however data from the navigation equipment cannot be re-
ceived.
Select output data to the navigation equipment that is com-
patible with FURUNO TLL. You can select more than one
datum.
• [Depth]: Output the depth data.
• [Temperature]: Output the water temperature* data.
• [Fish Size]: Output the fish size data. This function re-
quires the baud rate be set to 38400 bps.
Select a TLL output data to the navigation equipment.
• [Off]: No output of the longitude/latitude data.
• [TLL]: Output the longitude/latitude* data.
• [FURUNO-TLL]: Output the longitude/latitude* data and
the data that is selected at [Output Data]. This function re-
quires the connection with the navigation equipment that
is compatible with FURUNO TLL.
Not used. The setting is fixed.
Select a baud rate (4800 or 38400 bps).
Note: Select "38400 bps" when the [TLL Output] is set to
[FURUNO-TLL]. "4800 bps" may slow the transmission of
sentences.
) to close the communication port monitor window.
Description