Table of Contents
Advertisement
3. INITIAL SETTINGS
Menu item
[Voltage]
[Band Width]
Note 1: If the transducer settings are not correct, the following message appears.
Click the [OK] button to close the message, then confirm the transducer settings.
Note 2: If you select a transducer that does not support the IDENTI-FISH
IDENTI-FISH
Note 3: System reboot is required to apply the transducer settings. The following con-
firmation message appears. The equipment is automatically shut down after clicking
the [Yes] button. After completing the shut down, turn the transceiver unit off, then re-
place the transducer. After replacing the transducer, reboot the system.
3-10
Set the transmission voltage of the transducer (unit: V). The setting
range depends on the setting value for [Freq (Manual)]. This menu
item is enabled when [XDCR Select] is set to [Manual]. If [TD-ID] or
[Model] is selected, the voltage is automatically entered and the set-
ting is fixed.
Set the band width of the transducer (unit: kHz). The setting range
depends on the setting value for [Freq (Manual)]. This menu item is
enabled when [XDCR Select] is set to [Manual].
Warning
Transducer settings are not correct.
Check the settings.
™
feature is enabled, the following confirmation message appears.
Attention
The connected transducer is not compatible with IDENTI-FISH
Echo. IDENTI-FISH Echo display is not available.
Confirm
System will shut down to apply changes. Check the transducer and
settings before restarting the system.
Are you sure?
Yes
Description
OK
OK
No
™
while the
Hide quick links:
Advertisement
Table of Contents
