Table of Contents
Advertisement
3. INITIAL SETTINGS
5. Select the display resolution of the sub monitor that is connected to HDMI2 port
from the [Sub Monitor Display Resolution] pull-down list.
• [XGA]: 1024×768
• [SXGA]: 1280×1024
• [UXGA]: 1600×1200
6. To display the IDENTI-FISH
nal IDENTI-FISH Echo Window] to [On]. When [Off] is selected, you can drag the
graph window, etc. to the sub monitor. Echoes are not displayed on the sub mon-
itor.
7. When a net sonde is connected, click the
ton for [Net Depth Mark] to open the [Mark ID] win-
dow. When not connected, go to step 9.
8. Assign the net sonde ID to a net mark (0 to 15),
then click the [OK] button.
Note: Assign a different net sonde ID to each
net mark. If the duplicate IDs are found, the
message to the right appears.
9. When the Simrad ITI net sensor is connected,
select [ITI Net Sensor] from the [IIMTW Sen-
tence] pull-down list. When not connected, se-
lect [Off] or [Water Temperature Gauge].
Note: The following net sensors are compatible with this equipment.
10. Select [On] or [Off] from the [Date Auto Adjust] pull-down list.
• [Off]: Manually set the system time.
• [On]: The system time is automatically adjusted according to the date from the
navigation equipment.
When [Off] is selected, go to step 11. Otherwise, go to step 13.
11. Click the
[Date Setting] window, then enter the appropriate
date manually and click the [OK] button.
3-2
™
echo window on the sub monitor, select the [Exter-
Manufacturer
Marport
Imaginex
Simrad
button for [Date Setting] to open the
• [Full HD]: 1920×1080
• [WUXGA]: 1920×1200
but-
Mark0
Mark1
Mark2
Mark3
Mark4
Mark5
Mark6
Mark7
Mark8
Mark9
Mark10
Mark11
Mark12
Mark13
Mark14
Mark15
Duplicate MARK IDs found. Check the settings.
Model
TE-155
TS-337A
ITI System
Mark ID
OK
Cancel
Attention
OK
Date Setting
OK
Cancel
Hide quick links:
Advertisement
Table of Contents
