Ac Power Cord Specifications For Mx10003 Routers - Juniper MX10003 Hardware Manual

General Electrical Safety Guidelines and Warnings | 206
Prevention of Electrostatic Discharge Damage | 182

AC Power Cord Specifications for MX10003 Routers

A detachable AC power cord is supplied with the AC power supplies. The coupler is type C13 as described
by International Electrotechnical Commission (IEC) standard 60320. The plug at the male end of the power
cord fits into the power source outlet that is standard for your geographical location.
CAUTION:
with that power supply only and not for any other use.
NOTE: In North America, AC power cords must not exceed 4.5 meters in length, to comply with
National Electrical Code (NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52 and Canadian
Electrical Code (CEC) Section 4-010(3). The cords supplied with the switch are in compliance.
Table 14 on page 39 gives the AC power cord specifications for the countries and regions listed in the
table.
Table 14: AC Power Cord Specifications
Country/Region
Argentina
Australia
Brazil
China
Europe (except Italy,
Switzerland, and United
Kingdom)
India
Israel
The AC power cord provided with each power supply is intended for use
Electrical Specifications
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
Plug Standards
IRAM 2073 Type RA/3
AS/NZZS 3112 Type
SAA/3
NBR 14136 Type BR/3
GB 1002-1996 Type PRC/3
CEE (7) VII Type VIIG
IS 1293 Type IND/3
SI 32/1971 Type IL/3G
Juniper Model Number
CBL-EX-PWR-C13-AR
CBL-EX-PWR-C13-AU
CBL-EX-PWR-C13-BR
CBL-EX-PWR-C13-CH
CBL-EX-PWR-C13-EU
CBL-EX-PWR-C13-IN
CBL-EX-PWR-C13-IL
39