Management Port Connector Pinouts For The Qfx Series; Table 59: Rj-45 Management Port Connector Pinouts For The Qfx Series - Juniper QFX10016 Hardware Manual

Related
Documentation

Management Port Connector Pinouts for the QFX Series

Table 59: RJ-45 Management Port Connector Pinouts for the QFX Series

Pin
1
2
3
4
5
6
7
8
Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
NOTE: USB flash drives used with the QFX Series device must support
USB 2.0 or later.
Creating an Emergency Boot Device on page 285
Performing a Recovery Installation Using an Emergency Boot Device on page 287
The 1000BASE-T RJ-45 management ports use an RJ-45 connector to connect either
to the control plane and management network in a QFabric system, or to a management
device for out-of-band management.
Table 59 on page 137 provides the pinout information of the RJ-45 management port
connector. An RJ-45 cable is supplied with the QFX Series device.
NOTE: The RJ-45 pinout information in
the QFX5100-48T device 10GBASE-T access ports.
Signal
TRP1+
TRP1–
TRP2+
TRP3+
TRP3–
TRP2–
TRP4+
TRP4–
Management Port LEDs on a QFX3100 Director Device
Management Port LEDs in the QFX3600 and QFX3600-I Device
Management Port LEDs on a QFX3500 Device
Management Port LEDs on a QFX5100 Device
Chapter 11: Pinout Specifications
Table 59 on page 137 also applies to
Description
Transmit/receive data pair 1
Transmit/receive data pair 1
Transmit/receive data pair 2
Transmit/receive data pair 3
Transmit/receive data pair 3
Transmit/receive data pair 2
Transmit/receive data pair 4
Transmit/receive data pair 4
137