Replacing The Mx10003 Air Filter - Juniper MX10003 Hardware Manual

To install the air filter unit:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Ensure that the air filter unit is right side up.
3. Grasp the air filter unit and slide into the rails on the cable management brackets until it stops (see
Figure 35 on page 119). The air filter unit fits snugly on the cable management brackets.
Figure 35: Installing the Air Filter
4. Tighten the captive screws to secure the air filter unit.
SEE ALSO
MX10003 Cooling System Description | 31
Prevention of Electrostatic Discharge Damage | 182

Replacing the MX10003 Air Filter

IN THIS SECTION
Removing the MX10003 Air Filter | 120
Installing the MX10003 Air Filter | 121
119