Juniper MX10003 Hardware Manual page 109

If the status LED on the power supply is blinking red, the power supply is not functioning normally.
Repeat the installation and cabling procedures.
NOTE: After powering off a power supply, wait at least 60 seconds before turning it back
on. After powering on a power supply, wait at least 60 seconds before turning it off.
If the system is completely powered off when you power on the power supply, the Routing
Engine (or RCB) boots as the power supply completes its startup sequence. If the Routing
Engine finishes booting and you need to power off the system again, first issue the CLI
request system halt command.
After a power supply is powered on, it can take up to 60 seconds for status indicators—such
as the status LEDs on the power supply and the show chassis command display—to indicate
that the power supply is functioning normally. Ignore error indicators that appear during the
first 60 seconds.
10. On the external management device connected to the RCB, monitor the startup process to verify that
the system has booted properly.
SEE ALSO
MX10003 Router Grounding Specifications | 61
request system halt
show chassis power
General Safety Guidelines and Warnings | 177
General Electrical Safety Guidelines and Warnings | 206
Prevention of Electrostatic Discharge Damage | 182
109