Removing/Installing Group 24 Battery Box Sub-Frame - Invacare Arrow RWD Service Manual

Removing/Installing Group 24 Battery Box Sub-Frame

NOTE: For this procedure, refer to FIGURE 12.13 on page 126.
Removing
1. Remove the battery boxes. Refer to Removing/Installing Battery Boxes on page 121.
2. Remove the two mounting screws and locknuts that secure the wiring harness
w/bracket and the sub-frame to the base frame.
3. Perform one of the following:
• Wheelchairs Equipped with Vent Tray - Remove the four mounting screws that
secure the shocks, retainer bar, spacers and retainer clips to the base frame.
• Wheelchairs without Vent Tray - Remove the four mounting screws that secure the
shocks and spacers to the base frame.
4. Remove the existing sub-frame assembly.
Installing
1. Install the two mounting screws and locknuts that secure the wiring harness with
bracket and the new sub-frame to the base frame. Use Loctite 242 and torque
mounting screws to 160 in-lbs (13.36 ft-lbs)(18.03 Nm).
2. Perform one of the following:
• Wheelchairs Equipped with Vent Tray - Reinstall the four mounting screws that
secure the shocks, retainer bar, spacers and retainer clips to the base frame. Use
Loctite 242 and torque mounting screws to 160 in-lbs (13.36 ft-lbs)(18.03 Nm).
• Wheelchairs without Vent Tray - Reinstall the four mounting screws that secure the
shocks and spacers to the base frame.
3. Reinstall the battery boxes. Refer to Removing/Installing Battery Boxes on page 121.
Use Loctite 242 and torque mounting screws to 160 in-lbs (13.36 ft-lbs)(18.03 Nm).
Part No. 1104849
125
SECTION 12—BATTERIES
3G Storm Series® Wheelchairs