Komatsu D61EX-24 Operation & Maintenance Manual page 295

TRANSPORTATION
5.
Select the lifting tool such as wire ropes and slings match-
ing to the weight of the machine, and fit the wire ropes to
the slinging position.
(A) Mark indicating slinging position
NOTICE
• Use protectors, etc. so that the wire ropes will not
be broken at sharp edges or narrow places.
• When using a spreader beam, select an ample
width to prevent contact with the machine.
6.
Just before slinging the machine, lift it off the ground by
100 to 200 mm {3.9 to 7.9 in} while it is being set.
7.
Check that the wire ropes are free of looseness and the
machine is kept on a level state.
8.
Sling the machine slowly.
3-244
OPERATION