Komatsu D61EX-24 Operation & Maintenance Manual page 292

OPERATION
7.
Place the parking brake lever in FREE position (F).
8.
Set the speed range to 1st or less in variable mode.
9.
Set the travel direction toward the ramps and drive slowly.
The center of gravity of the machine shifts suddenly at the
joint between the ramps and the trailer, and the machine is
unbalanced and becomes unstable. Drive the machine
carefully and slowly.
10. Place the machine at the specified position on the trailer.
METHOD FOR SECURING MACHINE
If the end of blade is out of the trailer, angle the blade.
NOTICE
Be sure to lower the car radio antenna to the stow position.
After loading the machine onto a trailer, secure the machine as follows.
1.
Lower the work equipment slowly.
(When transporting with work equipment installed)
2.
Set the work equipment lock lever securely to LOCK posi-
tion (L).
3.
Set the parking brake lever securely to LOCK position (L).
4.
Stop the engine, and remove the key from the starting
switch.
5.
Securely lock the glass window, cab door, engine side cov-
er, hydraulic tank inspection cover, DEF tank filler port cov-
er, and fuel tank inspection cover.
6.
Put wooden blocks (1) to the front and rear of the R.H. and
L.H. tracks.
7.
Fix the machine securely with chains or wire ropes of ap-
propriate strength with method (A) or (B).
Secure the machine so that it will not move during transportation.
In particular, fix the machine securely to prevent it from slipping sideways.
k k
WARNING
TRANSPORTATION
3-241