Siemens SIMATIC ET 200S Manual page 508

4 IQ-SENSE
Control interface (PIQ)
Table 14-4 Enhanced control interface
Address
Byte 0
Byte 1
14-12
Assignment
Specify sensitivity/distance value on
channel 0
•
Bit 0:
1: Transfer sensitivity/distance value to the
sensor on channel 0
(using rising edge)
0: Deactivated
•
Bit 1 to bit 7:
Sensitivity/distance value
on channel 0: 1 to 126 (depending on the
sensor)
Teach-in on the sensor on channel 0
•
Bit 0:
1: Start teach-in on the sensor on channel 0
(at the rising edge)
0: Deactivated
•
Bit 1 to bit 7: 0
Specify sensitivity/distance value on
channel 1 channel 1
•
Bit 0: Bit 0:
1: Transfer sensitivity/distance value to the
sensor on channel 1 sensor on channel 1
(using rising edge)
0: Deactivated 0 D ti t d
• • Bit 1 to bit 7: Bit 1 to bit 7:
Sensitivity/distance value
on channel 1: 1 to 126 (depending on the on channel 1: 1 to 126 (depending on the
sensor)
Teach-in on the sensor on channel 1
•
Bit 0:
1: Start teach-in on the sensor on channel 1
(at the rising edge)
0: Deactivated
•
Bit 1 to bit 7: 0
Designation on
"IQ-SENSE Opto" FB
WR_TEACH_VAL
TEACH_VAL_IN
START_TEACH
WR_TEACH_VAL
TEACH_VAL_IN
START_TEACH
ET 200S Distributed I/O System
EWA-4NEB780602402-09