Siemens SIMATIC ET 200S Manual page 420

Analog Electronic Modules
Table 13-33 Parameters for analog input modules RTD, TC, continued
2AI RTD 2AI TC
Standard Standard
––– Type/range
of measure-
ment
1)
Only with thermocouples. A parameter assignment error occurs when the wire break diagnosis is enabled
in the voltage measuring range. The module does not start up.
2)
The wire break is only detected with constant-current lines.
13-36
2AI TC High
Feature
•
––– Deactivated
• Voltage
• TC-EL type T (Cu-CuNi)
• TC-EL type K (NiCr-Ni)
• TC-EL type B (PtRh-PtRh)
•
TC-EL type N (NiCrSi-NiSi)
•
TC-EL type E (NiCr-CuNi)
•
TC-EL type R (PtRh-Pt)
• TC-EL type S (PtRh-Pt)
• TC-EL type J (Fe-Cu-Ni)
• TC-EL type L (Fe-Cu-Ni)
Type/range of • Deactivated
measurement
•
Voltage
•
TC-EL type T (Cu-CuNi)
•
TC-EL type K (NiCr-Ni)
•
TC-EL type B (PtRh-PtRh)
• TC-EL type C (WRe-WRe)
• TC-EL type N (NiCrSi-NiSi)
• TC-EL type E (NiCr-CuNi)
•
TC-EL type R (PtRh-Pt)
•
TC-EL type S (PtRh-Pt)
•
TC-EL type J (Fe-Cu-Ni)
•
TC-EL type L (Fe-Cu-Ni)
Value range
80 mV
$
80 mV
$
ET 200S Distributed I/O System
Default Applica-
bility
TC-EL Channel
type K
(NiCr-Ni)
TC-EL Channel
type K
(NiCr-Ni)
EWA-4NEB780602402-09