Power On/Reset Counts - Omron MicroHAWK V320-F User Manual

H-18 Power On/Reset Counts
• Note: Power On/Reset Counts is a read-only command.
Power-On
Serial Cmd:
Power-On uses a 16-bit counter that increments each time the reader is powered-on.
Resets
Serial Cmd:
Resets uses a 16-bit counter that increments each time the reader is reset. This value is reset at
power-on.
Power-On Saves
Serial Cmd:
Power-On Saves uses a 16-bit counter that increments each time an reader setting is saved for power-
on with a <Z> command.
Power-On Flash Saves
Serial Cmd:
Power-On Flash Saves uses a 16-bit counter that increments each time an reader setting is saved to
the customer parameter section of flash memory with a <Zc> command.
MicroHAWK V320-F / V330-F / V420-F / V430-F Barcode Reader User Manual
<K406,power-on,resets,power-on saves,power-on flash saves>
<K406,power-on,resets,power-on saves,power-on flash saves>
<K406,power-on,resets,power-on saves,power-on flash saves>
<K406,power-on,resets,power-on saves,power-on flash saves>
Appendices
H
H-43