Database Identifier Output - Omron MicroHAWK V320-F User Manual

Appendices
H-23 Database Identifier Output
Usage:
Serial Cmd:
Default:
Options:
H-23-1 Output Status
Disabled
When this command is disabled, no database identifier information will be output.
Enabled
When this command is enabled, the reader will append a two-digit number and the characters "DB" to the
data output following the separator for each symbol decoded using Configuration Database. For example,
if the separator is an underscore character and the second database entry reads a symbol encoded with
"data capture" during the read cycle, the symbol data output will be "data capture_DB02". If the
database is not active, no identifiers will be attached to output.
H-23-2 Separator
Usage:
Serial Cmd:
Default:
Options:
H-48
Useful in keeping track of which database entries read which symbols.
<K759,status,separator>
0
0 = Disabled
The separator character separates the symbol data from the database
identifier.
<K759,status,separator>
<space>
Any ASCII character.
MicroHAWK V320-F / V330-F / V420-F / V430-F Barcode Reader User Manual
1 = Enabled