2 Quick Start
2-2-13 Run the Application
In the Run view, you can observe the progress of the setup as it follows the parameters you have
defined. The right panel of the UI shows Counts for Cycles, Reads, No Reads, and Mismatches, as
well as Rate information for Capture, Decode, Overhead, Total Read, and Trigger Rate, as well as
Output Data. A "filmstrip" below the Image Area shows each image capture with a green check mark
for a good read and a red x for a no read.
2-30
MicroHAWK V320-F / V330-F / V420-F / V430-F Barcode Reader User Manual