Multisymbol - Omron MicroHAWK V320-F User Manual

Appendices
F-3

Multisymbol

Usage:
Definition:
Conditions:
F-3-1 Number of Symbols
Definition:
Serial Cmd:
Default:
Options:
F-3-2 Multisymbol Separator
Usage:
Definition:
Serial Cmd:
Default:
Options:
• Note: If No-Read messages are disabled and there are No-Reads occurring, separators will only be inserted between
symbol data outputs.
F-4
Multisymbol is commonly used in shipping applications where a shipping
symbol contains individual symbols for part number, quantity, etc. This
feature allows on trigger to pick up all the symbols.
Multisymbol allows the user to define up to 100 symbols that can be read
in a single read cycle.
The following conditions apply:
• Each symbol must be different to be read, unless in Rapid Capture
Mode, configured for "triggered capture".
• The maximum number of characters in a read cycle is 3,000 for all
symbols.
• All No-Read messages are posted at the end of the data string, unless
output filtering is enabled.
• If more than one symbol is within the field of view at the same time,
symbol data may not be displayed in the order of appearance.
• If Matchcode Type is set to Sequential or if Trigger is set to Continuous
Read 1 Output, the reader will behave as if Number of Symbols were
set to 1, regardless of the user-defined configuration.
Number of Symbols is the number of different symbols that can be read in
a single read cycle.
<K222,number of symbols, multisymbol separator>
1
1 to 100
Used to delimit or separate data fields with a user defined character.
Any valid ASCII character, inserted between each symbol read when Multisymbol
is set to any number greater than 1.
<K222,number of symbols,multisymbol separator>
, (comma)
Any available ASCII character.
MicroHAWK V320-F / V330-F / V420-F / V430-F Barcode Reader User Manual