Omron MicroHAWK V320-F User Manual page 95

4 Setup
4-5-1 Replace Character
Format Output also has a Replace Character feature. You can access the Replace Character feature
by clicking on the Replacements link in the Format Output editor.
Before clicking on the Replacements link, note the two other boxes below the link: Remove Control
Characters and Remove Extended Characters. These are used to remove all ASCII control
characters and ASCII extended characters from decoded barcode data. A complete ASCII table is
available for reference here. Control characters are defined as 1-31, and extended characters are
defined as 127-255.
Click on the Replacements link to open the replacements dialog shown below.
Character: The character that you want to replace.
Replace Count: How many characters you want the character to be replaced with. Valid options are 0, 1, and 2.
Replacement: The character(s) that you want to replace the character with.
When you replace a character with one or more different characters, the results will be displayed in the
Output Data window in the lower right panel of the WebLink user interface. Up to 25 character
replacements can be defined. If duplicates are defined, an error message will appear, and only the first
definition will be applied.
You can enter ASCII control characters by selecting the link below the input box. You can also enter
extended ASCII characters by entering \xHexadecimal - for example: \xFF.
The number of replacements that you've defined are counted in the Replacements link in the Format
Output editor.
4-16
MicroHAWK V320-F / V330-F / V420-F / V430-F Barcode Reader User Manual