Table of Contents
Advertisement
When installing a child restraint system
■
You may need a locking clip to install the
child restraint system. Follow the instruc-
tions provided by the manufacturer of the
system. If your child restraint system does
not provide a locking clip, you can purchase
the following item from your Lexus dealer:
Locking clip for child restraint system (Part
No. 73119-22010)
WARNING
When installing a child restraint sys-
■
tem
Observe the following precautions.
Failure to do so may result in death or
serious injury.
Do not allow children to play with the
●
seat belt. If the seat belt becomes
twisted around a child's neck, it may
lead to choking or other serious inju-
ries that could result in death. If this
occurs and the buckle cannot be
unfastened, scissors should be used to
cut the belt.
Ensure that the belt and plate are
●
securely locked and the seat belt is not
twisted.
Shake the child restraint system left
●
and right, and forward and backward
to ensure that it has been securely
installed.
After securing a child restraint system,
●
never adjust the seat.
When a junior seat (booster seat) is
●
installed, always ensure that the shoul-
der belt is positioned across the center
of the child's shoulder. The belt should
be kept away from the child's neck, but
not so that it could fall off the child's
shoulder.
Follow all installation instructions pro-
●
vided by the child restraint system
manufacturer.
RC350-RC300_OM_General_OM24884E
1-2. Child safety
Child restraint system fixed with
an ISOFIX lower anchorage
ISOFIX lower anchorages
■
(ISOFIX child restraint system)
Lower anchorages are provided for the
each rear seats. (Mark displaying the
location of the anchorages are
attached to the seats.)
Installation with ISOFIX lower
■
anchorage (ISOFIX child restraint
system)
Install the child restraint system in
accordance to the operation manual
enclosed with the child restraint sys-
tem.
If the child restraint system on hand is
not within the "universal" category (or
the necessary information is not in the
table), refer to the "Vehicle List" pro-
vided by the child restraint system
maker for various possible installation
positions, or check the compatibility
after asking the retailer of the child
seat. (P.56, 59, 63, 66)
1
Adjust the seatback angle to the
most upright position.
When installing a forward-facing
child seat, if there is a gap between
73
1
Advertisement
Table of Contents
