Table of Contents
Advertisement
140
3-3. Adjusting the seats
performed, the driver's seat and steer-
ing wheel
original positions.
The engine switch has been turned
to ACCESSORY mode or IGNI-
TION ON mode.
The driver's seat belt has been fas-
tened.
*
: Power type
Operation of the power easy access sys-
■
tem
When exiting the vehicle, the power easy
access system may not operate if the seat is
already close to the rear position, etc.
Customization
■
Some functions can be customized.
(P.405)
Recording a driving position into
memory (vehicles with driving
position memory)
1
Check that the shift lever is in P.
2
Turn the engine switch to IGNI-
TION ON mode.
Adjust the driver's seat, steering
3
wheel, and outside rear view mir-
rors to the desired positions.
4
While pressing the "SET" button, or
within 3 seconds after the "SET"
button is pressed, press button "1",
"2" or "3" until the buzzer sounds.
If the selected button has already been
preset, the previously recorded position
RC350-RC300_OM_General_OM24884E
*
automatically return to their
will be overwritten.
WARNING
Seat adjustment caution
■
Take care during seat adjustment so that
the seat does not strike the rear passen-
ger or squeeze your body against the
steering wheel.
Recalling a driving position
(vehicles with driving position
memory)
1
Check that the shift lever is in P.
2
Turn the engine switch to IGNI-
TION ON mode.
3
Press one of the buttons for the
driving position you want to recall
until the buzzer sounds.
To stop the position recall operation
■
part-way through
Perform any of the following:
Advertisement
Table of Contents
