WARNING
If the vehicle is stopped by the opera-
●
tion of the pre-collision braking func-
tion, the pre-collision braking function
operation will be canceled after
approximately 2 seconds. Depress the
brake pedal as necessary.
The pre-collision braking function may
●
not operate if certain operations are
performed by the driver. If the acceler-
ator pedal is being depressed strongly
or the steering wheel is being turned,
the system may determine that the
driver is taking evasive action and pos-
sibly prevent the pre-collision braking
function from operating.
In some situations, while the pre-colli-
●
sion braking function is operating,
operation of the function may be
canceled if the accelerator pedal is
depressed strongly or the steering
wheel is turned and the system deter-
mines that the driver is taking evasive
action.
If the brake pedal is being depressed,
●
the system may determine that the
driver is taking evasive action and pos-
sibly delay the operation timing of the
pre-collision braking function.
When to disable the pre-collision sys-
■
tem
In the following situations, disable the
system, as it may not operate properly,
possibly leading to an accident resulting
in death or serious injury:
When the vehicle is being towed
●
When your vehicle is towing another
●
vehicle
When transporting the vehicle via
●
truck, boat, train or similar means of
transportation
When the vehicle is raised on a lift with
●
the engine running and the tires are
allowed to rotate freely
RC350-RC300_OM_General_OM24884E
4-5. Using the driving support systems
When inspecting the vehicle using a
●
drum tester such as a chassis
dynamometer or speedometer tester,
or when using an on vehicle wheel bal-
ancer
When a strong impact is applied to the
●
front bumper or front grille, due to an
accident or other reasons
If the vehicle cannot be driven in a sta-
●
ble manner, such as when the vehicle
has been in an accident or is malfunc-
tioning
When the vehicle is driven in a sporty
●
manner or off-road
When the tires are not properly
●
inflated
When the tires are very worn
●
When tires of a size other than speci-
●
fied are installed
When tire chains are installed
●
When a compact spare tire or an
●
emergency tire puncture repair kit is
used
If equipment (snow plow, etc.) that may
●
obstruct the radar sensor or camera
sensor is temporarily installed to the
vehicle
Changing settings of the pre-col-
lision system
Enabling/disabling the pre-colli-
■
sion system
The pre-collision system can be ena-
bled/disabled on
multi-information display.
The system is automatically enabled each
time the engine switch is turned to IGNI-
TION ON mode.
199
(P.106) of the
4