178
4-3. Operating the lights and wipers
When the light switch is in
●
headlights and all lights turn off automati-
cally if the engine switch is turned to
ACCESSORY mode or turned off.
To turn the lights on again, turn the engine
switch to IGNITION ON mode, or turn the
light switch off once and then back to
or
.
Light reminder buzzer
■
A buzzer sounds when the engine switch is
turned off or turned to ACCESSORY
mode and the driver's door is opened while
the lights are turned on.
Automatic headlight leveling system
■
The level of the headlights is automatically
adjusted according to the number of pas-
sengers and the loading condition of the
vehicle to ensure that the headlights do not
interfere with other road users.
Customization
■
Some functions can be customized.
(P.405)
NOTICE
To prevent battery discharge
■
Do not leave the lights on longer than
necessary when the engine is not run-
ning.
Turning on the high beam head-
lights
RC350-RC300_OM_General_OM24884E
1
With the headlights on, push the
: The
lever away from you to turn on the
high beams.
Pull the lever toward you to the center
position to turn the high beams off.
2
Pull the lever toward you and
release it to flash the high beams
once.
You can flash the high beams with the
headlights on or off.
Follow me home system (if
equipped)
This system allows the headlights and
front position lights to be turned on for
30 seconds when the engine switch is
off.
Pull the lever toward you and release it
with the light switch is in
turning the engine switch off.
Pull the lever toward you and release it
again to turn off the lights.
Cornering lights
When the steering wheel or turn
signal lever is operated while the
headlights are on (low beam) and
the vehicle speed is 30 km/h (19
after